Heat Hero Gravity & Gravity Booster Kit

Heat Hero Gravity is designed to improve the safety, circulation and efficiency of all traditional solid fuel and dual solid fuel heating systems. Heat Hero is the only system available that has gravity, an open vent and is fully pumped by a strong 8 metre circulating pump for fast circulation and more efficiency.

Heat Hero Gravity

Heat Hero Gravity

Heat Hero Gravity Booster Kit

Heat Hero Gravity Booster Kit
gravity-diagram

HEAT HERO GRAVITY INSTALLATION INSTRUCTIONS

  1. Heat Hero Gravity Flow Manifold can be installed anywhere along the gravity flow and can be rotated in any direction.
  2. Heat Hero Gravity Return Manifold can be installed anywhere along the gravity return and can be rotated in any direction.
  3. The Circulating Pump. We recommend that an 8m Pump is installed and set to its fastest speed; to achieve maximum circulation and efficiency.
  4. The Pipe Thermostat must be of good quality and set at 55°. The pipe thermostat should be fitted as close to the solid fuel boiler as possible without damaging it.
  5. Expansion pipe of minimum ¾ “ diameter must be connected to the highest point on the gravity flow.
  6. The Cold Feed Connection must be connected into gravity return.
  7. The Heating Storage Tank Should be a minimum of 1m above the highest point of the heating System. (e.g. above the gravity flow or the highest radiator).
  8. Heat Hero Injector Pipe. A valve must be installed on the injector pipe and set at 1/4 or 1/2 open to balance the circulation of hot water through the cylinder.
  9. Heating Zones If the heating system is zoned, at least one radiator zone must be open when the solid fuel circulation pump comes on.

HEAT HERO GRAVITY can also be installed into a dual heating system with a single coil open vented cylinder Contact technical for more information.